12/3/2023 0 Comments Copper rivets for leatherI haven't had that problem with any of my #9s from a few different sources. Some guys have said that the domer on Bob's will sometimes overlap a #9 head (I think it is sold as an 8/9?). My wife will tell other makers or look at something in a shop and comment that they should get a set from Bob. There are a few things I would not do without, and my wife says the setters are one of 'em. One sets the burr, one peens the shank after it is cut to length, and the third domes the head. Bob Douglas makes a three piece set for each of the three common sizes. Shameless plug, I am in not way afilliated, etc. Just saw this thread, I set quite a lot of copper rivets. I would also like to make a bag with copper rivets, but then I would also need copper plated double capped jiffys, and I'm not sure if they are even made.Īnyway, I'm calling Hansens tomorrow to get their prices on the solid brass rivets. I would use the double-capped brass jiffy rivets in all other places. I think I may have a solution though: use the solid brass rivets only on those areas that bear a load, three in the handle assembly (backs will be concealed under suede lining) and for each of the two shoulder strap D-ring fobs (if I really want to obsess, I could work out away to conceal this rivet back too, hmmmm). My only concern with the solid rivets is that the rivet backs on my straps and two locations on the back of the briefcase (unless I forgo rivets here) will be exposed, and the look of the smashed down post onto the burr is not the most elegant. ![]() I want to make sure a rivet never pops out on a customer. I get the feel that this is the strongest hold, especially for parts of my briefcases that have to bear a 30lbs load, though thick saddlestitching is also used in these areas. I like the method of using brute force to smash down the rivet post onto the burr. Now I'm thinking of going with solid rivets. For steel tubular rivets I stuck with OTB, about $5 for 100 and about $4 for 100 caps (brass plated only, old stock at that). I was trying to work with them six months ago but they didn't have the sizes I needed. ![]() Can you tell me exactly what head type and size of tubular rivets you ordered from Hansens.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |